CHANNEL MASTER TITAN TV ANTENNA PRE AMPLIFIER , THE HIGHEST GAIN LOWEST NOISE DEEP FRINGE ANTENNA MOUNTED TV PREAMPLIFIER

CHANNEL MASTER

MATV MAST MOUNTED PREAMPLIFIERS TITAN 2

[Image]

Their very high signal handling also makes them suitable for use as a mast mounted, ultra low noise distribution amplifier for use in small MATV systems. All models feature 75 ohm, input and output connections in line with modern headend engineering practice.

Four models are available.
- Model 7775 is a UHF only model. Will not pass VHF DISCONTINUED
- Model 7776 is a VHF only model. It includes a switchable FM trap. Will not pass UHF DISCONTINUED USE Winegard AP3700
- Model 7777 covers both VHF and UHF bands with separate amplification in each band for maximum signal handling. They may be configured for either separate or combined VHF and UHF inputs. They include a switchable FM trap.
- Model 7778 offers Spartan 3TM specifications in the die-cast TitanTM housing. Covers both VHF and UHF bands with separate amplification in each band for maximum signal handling. They may be configured for either separate or combined VHF and UHF inputs. They include a switchable FM trap.
Surface-mounted components for automated production and consistent high performance.
Rugged die-cast aluminum housing -fully shielded.
Simple installation -hardware included.
High gain and ultra low noise figure from latest generation transistors give optimum sensitivity.
Ultra linear transistors provide high output capability for optimum signal handling.
Optimum filtering for rejection of out-of-band signals.
Uninterrupted operation even under the harshest environmental conditions.
Full lightning and surge protection.
Cool running, redesigned 117 VAC power supply, Model 0747 is included with each model. Output voltage is +18VDC. UL and cUL listed, Power supply also available as a separate model.

MATV MAST MOUNTED PREAMPLIFIERS TiTAN 2

The Titan range of mast mounted amplifiers has been completely reengineered and updated. These amplifiers represent the ultimate in preamplifier performance. They are designed for use as an ultra low noise, ultra high gain preamplifier for deepest fringe applications and MATV headend applications. Their very high signal handling also makes them suitable for use as a mast mounted, ultra low noise distribution amplifier for use in small MATV systems. All models feature 75 Ohm input and output connections in line with modern headend engineering practice. 2 models are available.CHANNEL MASTER

WARNING: DO NOT OVER TIGHTEN F CONNECTOR ON TO THE PRE-AMP CONNECTIONS. GENTLY FINGER TIGHTEN ONLY OR YOU RISK BREAKING THE CONNECTOR OFF THE PRE-AMP CIRCUIT BOARD

MATV MAST MOUNTED PREAMPLIFIERS TiTAN 2 YouTube VIDEO on 7777

View Cart

7778 covers both VHF and UHF bands 23dB UHF 16 dB VHF sold out

* Surface-mounted components for automated production and consistent high performance.

* Rugged die-cast aluminum housing - fully shielded.

* Simple installation - hardware included.

* High gain and ultra low noise figure from latest generation transistors give optimum sensitivity.

* Ultra linear transistors provide high output capability for optimum signal handling.

* Optimum filtering for rejection of out-of-band signals.

* Uninterrupted operation even under the harshest environmental conditions.

* Full lightning and surge protection.

* Cool running, redesigned 117VAC power supply, Model 0747 is included with each model. UL and cUL listed. (Model 0747 power supply also available as a separate model.)

7777 7778

Number of Inputs* 1/2(VHF&UHF) 1/2(V~U~F)

Input and Output Impedance 75 75 Ohms

VHFGain 23 16 dB

VHF Noise Figure 2.8 3 dB

VHF Output 57 56 dBmV

Switchabile FM Trap Yes Yes

UHF gain 26 23

UHF noisEfigure 2 2.2 dB

UHF Output 51 5O dB

Model 7778 & 7777 offer Spartan 3 TM specifications in the diecast TitanTM housing, cover both VHF and UHF bands with separate amplification in each band for maximum. signal handling.They may be configured for either separate or combined VHF and UHF inputs.They include a switchable FM trap.
Titan 2 ^TM SPECIFICATIONS
Model 7775 DISCONTINUED 7776 DISCONTINUED 7777 7778

Number of Inputs* 1(UHF) 1(VHF) ½(VHF & UHF) ½ (VHF & UHF)

Input and Output Impedance 75 75 75 75 ohms

Input and Output Connectors Type F Type F Type F Type F

VHF Gain N/A 23 23 16 dB

VHF Noise Figure N/A 2.8 2.8 3.0 dB

VHF Output Capability** N/A 57 57 56

Switchable FM Trap N/A Yes Yes Yes

UHF Gain 26 N/A 26 23 dB

UHF Noise Figure 2.0 N/A 2.0 2.2 dB

UHF Output Capability** 51 N/A 51 50 dBmV

**Titan 2 ^TM SPECIFICATIONS**
Model	7775 DISCONTINUED	7776 DISCONTINUED	7777	7778
Number of Inputs*	1(UHF)	1(VHF)	½(VHF & UHF)	½ (VHF & UHF)
Input and Output Impedance	75	75	75	75	ohms
Input and Output Connectors	Type F	Type F	Type F	Type F
VHF Gain	N/A	23	23	16	dB
VHF Noise Figure	N/A	2.8	2.8	3.0	dB
VHF Output Capability**	N/A	57	57	56
Switchable FM Trap	N/A	Yes	Yes	Yes
UHF Gain	26	N/A	26	23	dB
UHF Noise Figure	2.0	N/A	2.0	2.2	dB
UHF Output Capability**	51	N/A	51	50	dBmV

* On Models 7777 and 7778, an internal switch selects either separate or combined VHF and UHF inputs.

** Output capability is quoted for 2 channels at -46 dB cross modulation.
Derate by 5 or 9 dB for 4 or 8 channels per band. Maximum input is output capability minus gain.

[Image]