CHANNEL MASTER TV ANTENNA SIGANAL PRE-AMPS GIVE YOU THE GREATEST IMPROVEMENT IN YOUR TV PICTURE QUALITY Highest gain is 7777

USE A PREAMP TO CLEAR UP YOUR PICTURE AND PULL IN DISTANT TV CHANNELS

$ FOR $ A PREAMP GIVES YOU THE MOST TV SIGNAL IMPROVEMENT FOR YOUR MONEY.

ADDING A PREAMP TO AN ANTENNA SYSTEM HAS THE SAME AFFECT ON YOUR TV RECEPTION AS WOULD INSTALLING AN ANTENNA UP TO 16 TIMES BIGGER

CM SPARTAN 3 MAST MOUNTED PREAMPS ARE THE MOST POPULAR PREAMPS IN THE USA. ALL MODELS HAVE 16DB GAIN ON VHF AND 23DB GAIN ON UHF.

All pre-amps have a power supply that plugs into an AC outlet inside the house that lowers the voltage and sends it up the coax to power the amplifier which is mounted up near the antenna. The benefit is that you get amplification before any line loss or noise and you don't have to run 117 AC up to your roof. NOTE: Don't install a regular splitter between the power supply and the pre-amp or you will short circuit the system and it won't work. You can install a special splitter that is power passive on only one port. Or put a DC Block on the outputs that don't run to the power supply. Also you can't put any type of matching transformers between the power supply and the pre-amp.

PREAMPLIFIERS

SPARTAN 3 Mast Mounted Preamplifiers

[Image]

The industry standard preamplifiers for over 20 years are now completely redesigned and updated. Performance is better than ever before and all the features you require are included. The industry standard 0064 DSB features a single 300 ohm VHF/UHF input and a single 75 ohm output. Variations are available for applications requiring separate VHF and UHF inputs; 75 ohm inputs; VHF only models and models with active UHF and passive VHF passbands.

Models 0065 DSB and 0265 DSB are not supplied with a power supply. They have been designed for optimized performance with a supply voltage of +12 to +22 VDC from a satellite receiver. This power is normally passed to the preamplifier via a 40121FD (for a one output LNB) or 40321FD (for a twin LNB and two outputs) which diplex (combine) the VHF/UHF signals on to the same cable as the satellite signals.

Surface-mounted components for automated production and consistent high performance.
Attractive, modern design for both outdoor unit and power supply.
Easiest installation in the industry.
High gain and ultra low noise figure from the latest generation transistors gives optimum sensitivity.
Separate VHF and UHF amplification plus the use of ultra linear transistors improve output capability for optimum signal handling.
Switchable and tunable FM traps provide full FM control where needed.
Uninterrupted operation even under the harshest environmental conditions.
Full lighting and surge protection.
Cool running, redesigned 117 VAC power supply, Model 0747 is included with each model except 0065 DSB and 0265 DSB. Output voltage is +18 VDC. UL and cUL listed. (Power supply is also available as a separate model.)
Models 0065 DSB and 0265 DSB are satellite receiver LNB voltage compatible. (+12 to +22 VDC)

Spartan 3 Specifications

VHF
UHF

FM Control

Model Inputs Input
Impe-
dance
Ohms Output
Impedance/
Down lead
Ohms Gain
dB Noise
Figure
dB Output
Capa-
bility
dBmV Gain
dB Noise
Figure
DB Output
Capa-
bility
dBmV Switch-
able
Trap Tunable
Trap Power
Supply

0064 DSB
0264 DSB
0068 DSB

0040 DSB

0065 DSB
0265 DSB 1 (VHF/UHF)
2 (VHF & UHF)
1 (VHF/UHF)

1 (VHF)

1 (VHF/UHF)
2 (VHF & UHF) 300
300
75

300

300
300 75
75
75

75

75
75 16
16
16

16

16
16 3.0
3.0
3.0

3.0

3.0
3.0 56
56
56

56

56
56 23
23
23

N/A

23
23 2.2
2.2
2.2

N/A

2.2
2.2 50
50
50

N/A

50
50 Yes
Yes
Yes

Yes

Yes
Yes Yes
Yes
Yes

Yes

Yes
Yes 0747Incl.
0747Incl.
0747Incl.

0747Incl.

Not Incl.**
Not Incl.**

0064DSB U/V/FM 300 OHM ( FLAT LEAD ) INPUT 75 OHM DOWN YouTube VIDEO SOLD OUT USE 0068DSB

0068DSB U/V/FM 75 ohm coax in and 75 OHM Down lead Pre-amp

View Cart

0264DSB U/V/FM SPLIT INPUT 300 OHM IN 75 OHM Down Lead ( use when you have a VHF antenna and a second UHF antenna)discontinued use CM 7778 No More 300 ohm inputs only coax

# 0268DSB U/V/FM SPLIT INPUT 75 OHM IN 75 OHM DOWN discontinued use CM 7778

# 0071DSB UHF ONLY 300 OHM IN 75 OHM DOWN Winegard AP4800 or AP4700 ( they are coax in and out)

# 0040DSB VHF/FM 300 OHM IN 75 OHM DOWN DISCONTINUED USE A WINEGARD AP3700 or AP3800

CM # 0747 Replacement pwr.supply for Titan and Spartan DSB pre-amps $24.95 plus shipping

View Cart

CHANNEL MASTER

MATV MAST MOUNTED PREAMPLIFIERS TITAN 2

[Image]

Their very high signal handling also makes them suitable for use as a mast mounted, ultra low noise distribution amplifier for use in small MATV systems. All models feature 75 ohm, input and output connections in line with modern headend engineering practice.

Four models are available.

Model 7776 is a VHF only model. It includes a switchable FM trap. Will not pass UHF DISCONTINUED USE Winegard AP3700
Model 7777 covers both VHF and UHF bands with separate amplification in each band for maximum signal handling. They may be configured for either separate or combined VHF and UHF inputs. They include a switchable FM trap.
Model 7778 offers Spartan 3TM specifications in the die-cast TitanTM housing. Covers both VHF and UHF bands with separate amplification in each band for maximum signal handling. They may be configured for either separate or combined VHF and UHF inputs. They include a switchable FM trap.

Surface-mounted components for automated production and consistent high performance.

Rugged die-cast aluminum housing -fully shielded.

Simple installation -hardware included.

High gain and ultra low noise figure from latest generation transistors give optimum sensitivity.

Ultra linear transistors provide high output capability for optimum signal handling.

Optimum filtering for rejection of out-of-band signals.

Uninterrupted operation even under the harshest environmental conditions.

Full lightning and surge protection.

Cool running, redesigned 117 VAC power supply, Model 0747 is included with each model. Output voltage is +18VDC. UL and cUL listed, Power supply also available as a separate model.

CHANNEL MASTER

MATV MAST MOUNTED PREAMPLIFIERS TiTAN 2 YouTube VIDEO of 7777

The Titan range of mast mounted amplifiers has been completely reengineered and updated. These amplifiers represent the ultimate in preamplifier performance. They are designed for use as an ultra low noise, ultra high gain preamplifier for deepest fringe applications and MATV headend applications. Their very high signal handling also makes them suitable for use as a mast mounted, ultra low noise distribution amplifier for use in small MATV systems. All models feature 75 Ohm input and output connections in line with modern headend engineering practice. Two models are available.

View Cart

7778 covers both VHF and UHF bands 23dB UHF 16 dB VHF

View Cart

Model 7778 & 7777 offer Spartan 3 TM specifications in the diecast TitanTM housing, cover both VHF and UHF bands with separate amplification in each band for maximum. signal handling.They may be configured for either separate or combined VHF and UHF inputs.They include a switchable FM trap.

* Surface-mounted components for automated production and consistent high performance.

* Rugged die-cast aluminum housing - fully shielded.

* Simple installation - hardware included.

* High gain and ultra low noise figure from latest generation transistors give optimum sensitivity.

* Ultra linear transistors provide high output capability for optimum signal handling.

* Optimum filtering for rejection of out-of-band signals.

* Uninterrupted operation even under the harshest environmental conditions.

* Full lightning and surge protection.

* Cool running, redesigned 117VAC power supply, Model 0747 is included with each model. UL and cUL listed. (Model 0747 power supply also available as a separate model.)

7777 7778

Number of Inputs* 1/2(VHF&UHF) 1/2(V~U~F)

Input and Output Impedance 75 75 Ohms

VHFGain 23 16 dB

VHF Noise Figure 2.8 3 dB

VHF Output 57 56 dBmV

Switchabile FM Trap Yes Yes

UHF gain 26 23

UHF noisEfigure 2 2.2 dB

UHF Output 51 5O dB

ALSO SEE CHANNEL MASTER SUPER TITAN PAGE

Channel Master INDEX PAGE

TO WINEGARD PREAMP

PAGE TO B-T PREAMP PAGE

FOR ALL TV ANTENNA PAGE>>>>>

FOR ALL TV ANTENNA PREAMPS (BEST WAY TO IMPROVE YOUR PICTURE QUALITY)>>>

CHANNEL MASTER MATV PRODUCTS

[Image] [Image] [Image] PDF INSTRUCTION SHEET

Channel Master NEW #3410 Amplifier, ultra mini, one output, 15 dB, 50 to 1002 MHz, with return path (PCT-MA2-M) Replaces CM 3042

View Cart

Channel Master NEW # 3412 INDOOR DISTRIBUTION AMP with 11.5 dB gain on ea of 2 Output $27.95

View Cart

Channel Master NEW # 3414 Replaces CM #3044 4-WAY 54-1002 mhz INDOOR DISTRIBUTION AMP with return path WE ARE SOLD OUT OF THE 3418 until Mid MARCH

You May be able to get a 3414 at this Link

Channel Master NEW # 3418 Replaces CM #3045 8-WAY YouTube VIDEO WE ARE SOLD OUT OF THE 3418 until Mid MARCH

You May be able to get a CM 3418 here

CM #7034C 33dB WIDE BAND(50-550 MHZ) AMPLIFIER 1 in and 1 out DISCONTINUED USE CM 7722 or BT ACA35-1000

CM #7054C 44dB WIDE BAND(50-550 MHZ) AMPLIFIER 1 in and 1 out DISCONTINUED USE BT Z C M - 4 8 - 5 5 0

MORE INFO ON 7020, 7034, 7054 >>>

CM #7335C V-U-FM 33dB DIST. 1 in 1 out AMPLIFIER DISCONTINUED USE CM 7722 OR BT ZTA35 BT # ZTA-35 BROADBAND U/V/FM DIST. AMP. 35dB SALE $111.66 LIST $203.05

HDTV OFF AIR ANTENNAS

[Image] NEW CM Catalog