Instructions on how to install Snap-N-Seal "F" connectors on Coax wire using the IT-1000 tool

Push down wire striping blade so that you can insert the RG-6 or RG-59 wire.

Be sure to insert the wire in the correct side. Let the blade clamp down on the wire.

The coax should extend just a little beyond the tool body. Twist the tool around the coax wire a few turns.

Hold the wire and pull the tool so it strips off the coax wire so it looks like this

Put the Snap-N-Seal ring up the coax as shown then push the connector on to the coax until the foam is even with the bottom of the inside of the threaded end of the connector. The body of the connector should easily push up under the foil and braid of the coax. You must use the correct Snap-N-Seal connector for the type of wire you are installing them on. Use SNS-59 on RG-59, SNS-6 on RG-6 that has one layer of foil and braid, and SNS-6QS must be used on "Quad-shield" Coax.

Move the handle away from the tool and put the wire with the connector in the tool cavity. Be sure the center conductor is straight.

Pull the lever toward the tool until you feel it "Snap" as the ring is forced into the connector making a weather tight seal

The connector is now installed on the coax and ready to use.

OTHER TYPES OF CONNECTORS AND ADAPTORS

AUGAT IT1000 SNAP-N-SEAL INSTALLATION/CABLE PREPARATION TOOL FOR SNS6 CONNECTORS IT 1000 SNAP-N-SEAL INSTALLATION & CABLE PREPARATION TOOL FOR SNS SERIES CONNECTORS. this combination tool strips the coax cable and installs the compression SNS connector on it. INSTRUCTION ON HOW TO USE THE IT1000

I am out of the IT1000 at this time but you can order one from the AMAZON Link Below

More Info on Snap n seal connectors and tools

SNAP-N-SEAL Environmentally sealed "F" Connector System for harsh environments through a unique 360 degree compression process. SNAP-N-SEAL also offers the signal leakage protection required for today's systems. (USE TOOL IT 1000 TO INSTALL SNAP-N-SEAL)

SNS6 AUGAT LRC SANP-N-SEAL WEATHERPROOF ENVIRONMENTALLY SEALED "F" RG6 CONNECTOR

AUGAT SNS6 SNAP-N-SEAL CONNECTOR Quad-sealed system prevents moisture from migrating into the connection. 360 degree radial compression provides superior RFI integrity. Connector to cable retention 40 LB minimum. Manufactured of high quality 360 Brass, Cadmium plated with iridescent chromate coating for maximum corrosion resistance. This design also incorpororates UV resistant plastic and O-Rings providing a reliable environmentally sealed product.

Connector to cable retention 40 lbs minimum * Superb return loss performance of -30dB to 1GHz. *True 360 degree compression onto cable ensures superior RF shielding performance, -95dB effective shielding (typical on 60% bonded foil cable) and provides superior RF integrity. * Manufactured of high quality 360 brass, cadmium plated with yellow chromate coating for maximum corrosion resistance. * UV resistant plastic and O-rings provide a reliable environmentally